Subject:
|
Re: Port E inputs
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Fri, 14 Feb 1997 01:13:22 GMT
|
Original-From:
|
Fred G. Martin <fredm@mediaSAYNOTOSPAM.mit.edu>
|
Viewed:
|
3887 times
|
| |
|
|
the 6.270 has a diff anlg ckt. remember, the app b is generally
applicable, but some details are different.
-f
In your message you said:
> Hello,
>
> I noticed that in Figure B.9 on page 194 in Appendix B of the 6.270
> manual that pins PE0-PE3 are shown to go to seperate little port symbols
> while pins PE4-PE7 go to a block labeled 'Analog Input Header'. Do these
> inputs really go to two physically different connectors? On the
> handy-board it appears as if the analog inputs all go to one female
> socket strip on the lower left corner of the board. Is this correct? If
> so, do the numbers on the board, 0-6 correspond to PE0-PE6 respectively?
> Thanks.
>
> -Luke
>
>
>
>
>
|
|
Message is in Reply To:
 | | Port E inputs
|
| Hello, I noticed that in Figure B.9 on page 194 in Appendix B of the 6.270 manual that pins PE0-PE3 are shown to go to seperate little port symbols while pins PE4-PE7 go to a block labeled 'Analog Input Header'. Do these inputs really go to two (...) (30 years ago, 13-Feb-97, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
