 | | Re: Any way to reduce polygons?
|
| (...) I'm assuming you are generating a single, flattened stream of input, instead of defining subobjects which correspond to the subfiles in a model. If I'm wrong about that, ignore the rest of this message. One thing to do is to intercept any (...) (27 years ago, 16-Mar-00, to lugnet.cad)
| | |  | | Re: Any way to reduce polygons?
|
| If you are converting to POV format for rendering, perhaps you can find something useful in this thread: (URL) (27 years ago, 16-Mar-00, to lugnet.cad)
| | |  | | Re: Inside a 4548 Speed Regulator?
|
| (...) I've noticed that too. I've opened up one of my contollers once, because some sand grains got in between the speed knob and the housing and I had to clean it. I didn't check what you've asking about, but I think there is not mutch risk (...) (27 years ago, 16-Mar-00, to lugnet.trains)
| | |  | | Re: Efficiency was: Generating power
|
| in article e0.222e2ae.25fbc2e7@aol.com, lego-robotics@crynwr.com at lego-robotics@crynwr.com wrote on 3/11/00 7:40 AM: (...) That may have been my figure. Here's what I did. I connected two motors together and put a crank on each one. With no load, (...) (27 years ago, 16-Mar-00, to lugnet.robotics)
| | |  | | announcing Jain's Guide
|
| Jain's Guide ((URL) the premier guide to the fighting men, women and equipment of the sector is looking for reporters and photographers to submit stories and photos of the equipment and mecha used throughout the sector. ...Have you ever dreamed of (...) (27 years ago, 16-Mar-00, to lugnet.announce, lugnet.build.mecha)
|
Skipped 8 messages in
groups
lugnet.admin.terms, lugnet.off-topic.clone-brands, lugnet.off-topic.debate, lugnet.off-topic.geek (Skip-filter settings)
|