 | | Re: Six bladed propeller, pls help. —Tobbe Arnesson
|
| | | Thanks all! I'll answer you one by one. Geoffrey, I'm not quite sure I understand what you mean *blush*. Are you refering to the 1x4 plate with a hole in each end with "notches" around the hole and some half-bushings? This solution would make the (...) (24 years ago, 22-Sep-00, to lugnet.technic)
|
| | | |
| | | | | Re: Six bladed propeller, pls help. —Selçuk Göre
|
| | | | | (...) No no... It's built from the basic parts like 6-hole small technic pulleys, 1/2 pins and regular plates. This simple design dated from early 1980's, there was no such propellers exist at that time. Look at the picture (URL) for a fuzzy and (...) (24 years ago, 22-Sep-00, to lugnet.technic)
|
| | | | | |
| | | | | | | Re: Six bladed propeller, pls help. —Tobbe Arnesson
|
| | | | | | (...) That is an blurry picture indeed! It's impossible for me to make things out of it... Dang... (...) Well, the thickness should not be a problem. The propeller blade will have a length of 96mm or 12 studs, that's the radius for the prop folks ;) (...) (24 years ago, 22-Sep-00, to lugnet.technic)
|
| | | | | | |
| | | | | Re: Six bladed propeller, pls help. —Jennifer Clark
|
| | | | | (...) cone such as the yellow one found on the exhaust (?) of the 8860 supercar could make a good spinner as well - although it would be better in black or grey, of course. Jennifer Clark (24 years ago, 22-Sep-00, to lugnet.technic)
|
| | | | | |
| | | | | | | Re: Six bladed propeller, pls help. —Tobbe Arnesson
|
| | | | | | (...) Thanks! Taken out of my mind I think the spinner was supposed to be around 32mm in diameter and the cone is a little to pointy, I have to look into this, thanks for the idea Jennifer! Thank God I can go home now, work has been terrible, as (...) (24 years ago, 22-Sep-00, to lugnet.technic)
|
| | | | | | |
| | | | | Re: Six bladed propeller, pls help. —Travis Cobbs
|
| | | | "Tobbe Arnesson" <tnt@arnesson.nu> wrote in message news:39cb09b1.901912...net.com... (...) technic liftarm--either the 1x3 one (part 6632), or the 1x4 one (part 2825). This has a few consequences. One, it makes the structure slightly more compact (...) (24 years ago, 25-Sep-00, to lugnet.technic)
|
| | | | |
| | | | | | Re: Six bladed propeller, pls help. —Tobbe Arnesson
|
| | | | (...) *bonk* Now why didn't I think of that? Thanks :) /Tobbe (24 years ago, 25-Sep-00, to lugnet.technic)
|
| | | | |
