 | | Re: Six bladed propeller, pls help. —Andy Lynch
| | | | Tobbe, You could possibly use 2 of the Technic 3 bladed rotor parts, rotated 180 degrees from each other. This gives 6 blades, but 3 of them are set back 1 plate's depth. You could possibly build them up a bit to be even. The Technique 3 blade rotor (...) (24 years ago, 21-Sep-00, to lugnet.technic)
| | | | | | | | | | Re: Six bladed propeller, all in line - no problem —Klaas H. Meijaard
| | | | | Use indeed 2 Technic 3-bladed rotor parts, put on each blade 3 Technic half-beams (with rounded ends) and put the rotor parts on an axle, face to face, turned 180 degrees. Voila, plain and simpel, all propellor blades in line, further enlargements (...) (24 years ago, 21-Sep-00, to lugnet.technic)
| | | | | | | | | | | | Re: Six bladed propeller, all in line - no problem —Tobbe Arnesson
| | | | | (...) Et voila indeed! Hope I had the eight 3 blade rotors needed, do they come in black? I have to see if I can find a good source for them. Se my other answer in the original thread for my latest idea. Thanks! TGIF! /Tobbe (24 years ago, 22-Sep-00, to lugnet.technic)
| | | | | | | | | | | | RE: Six bladed propeller, all in line - no problem —Bram Lambrecht
| | | | | (...) I've noticed that 1x plates attached to the holes of a 6 hole pulley don't move around very much. So to make a propellor, (with 3 blades offset by one or two plates), attach 3 1x plates to a pulley so they stick straight out. Do the same on (...) (24 years ago, 22-Sep-00, to lugnet.technic)
| | | | | | |
