 | | Re: New Parts Drawings - Plates, Slope, Track Pieces —Mark Bellis
| | | | (...) OK, so the piece is like this: 1. The base is 3x3. 2. Is the corner a right angle, an 8mm radius curve, or a 16mm radius curve, like this piece? (URL) 3. I assume it has 2x2 studs on top, as if two 2x3s with curved top had been superimposed at (...) (19 years ago, 4-Feb-05, to lugnet.parts.custom, FTX)
| | | | | | | | | | Re: New Parts Drawings - Plates, Slope, Track Pieces —Steve Bliss
| | | | | (...) So, like one of these? (URL) Diagonal edge (URL) Round edge Steve (19 years ago, 4-Feb-05, to lugnet.parts.custom, FTX)
| | | | | | | | | | | | Re: New Parts Drawings - Plates, Slope, Track Pieces —Steve Bliss
| | | | | Oops, sorry. Here are some deep links, to use until the folder is moderated... (...) (URL) (...) (URL) Steve (19 years ago, 4-Feb-05, to lugnet.parts.custom, FTX)
| | | | | | |
