 | | Re: Lightweight show tables —Frank Filz
|
| | | (...) The table I built for an HO train layout used this kind of foam board. I built a frame out of 1x3 lumber. The top was anywhere from 2-4 1/2" layers of foam (I couldn't get the 1" thick material it would be a little stronger). My table was (...) (24 years ago, 27-Jan-01, to lugnet.trains)
|
| | | |
| | | | | Re: Lightweight show tables —James Trobaugh
|
| | | | | Currently our tables are made with 5/8 particle board tops and are about 3'x6'. We recently did a show for the Atlanta History Center and had to carry these beast up two flights of stairs to the room where we were displaying. I tell you after that (...) (24 years ago, 27-Jan-01, to lugnet.trains)
|
| | | | | |
| | | | | | | Re: Lightweight show tables —Frank Filz
|
| | | | | | (...) 5/8" is WAY thicker than you need, and particle board is heavier than plywood. The 3/8" that PNLTC specs is probably a good choice, though 1/4" is thick enough also. Frank (24 years ago, 27-Jan-01, to lugnet.trains)
|
| | | | | | |
| | | | | | | | Re: Lightweight show tables —James Trobaugh
|
| | | | | | The main reason for the 5/8 was so that I could attach folding metal legs to the bottom. I did the bolt on legs for a year and they just got to be too much. They took to long to set up and tear down, plus they ate up a ton of space in the van. I (...) (24 years ago, 28-Jan-01, to lugnet.trains)
|
| | | | | | |
| | | | | Re: Lightweight show tables —Tom Stangl
|
| | | | Note - if you want to spend a bit more money in the search for even lighter/thinner tables, you can build ones similar to Frank's, but use BIRCH plywood strips in place of the 1x3s - birch plywood is extremely stiff and light for it's size. Use 3/4" (...) (24 years ago, 11-Feb-01, to lugnet.trains)
|
| | | | |
