 | | Re: Pictures up from NGLTC Memorial Day display
|
| (...) What are the holes in the controller? Are these new/old? (image 49) KL (24 years ago, 30-May-00, to lugnet.trains, lugnet.trains.org, lugnet.general)
| | | | | Re: Pictures up from NGLTC Memorial Day display
|
| That was the controller being used on the interactive kid track. Basically it was 6'x6' track that did a figure 8 and went up the mountain. The holes in the controller were put there by me so that I could regulate the max speed for the controller in (...) (24 years ago, 30-May-00, to lugnet.trains, lugnet.trains.org, lugnet.general)
| | | | | Re: Controller speed
|
| (...) Just go out and get a 6V wall wart, or a variable wall wart (from Radio Shack), then run it at a apropriate setting...if the voltage input is limited, then the output will be too... James P (24 years ago, 30-May-00, to lugnet.trains, lugnet.trains.org, lugnet.general)
| | | | | Re: Controller speed
|
| James, I don't know if it would be that simple since the voltage coming in is 9-12AC and then converted over to 9V DC. And the solution I used didn't cost me any money, and I always like those kind of solutions. ;) jt (...) Shack), (...) the (...) (24 years ago, 30-May-00, to lugnet.trains, lugnet.trains.org)
| | | | | Re: Controller speed
|
| (...) You should be able to put dc into the speed regulator. As long as it doesn't have any transformers inside the AC-DC circuit should handle DC input with no problem. KL (24 years ago, 30-May-00, to lugnet.trains)
| |
