 | | Re: Scott Wardlaw's GE Dash 9 in Union Pacific Trim
|
|
(...) Thanks Jordan! Sorry for the late reply. I have been extremely busy lately. The three axle trucks are designed to handle the curves. The third axle floats left and right. I have used this design on several of my trains; running them through (...) (19 years ago, 18-Aug-07, to lugnet.trains, FTX)
|
| |
| | Re: RC/9v Train Wheel Question
|
|
(...) snip (...) Tony, I used 36 9volt train wheels to make my Schnabel Car. (URL) was left with 36 wheel housings that I could not think of a use for. Then I remembered that pick a brick on Shop at Home had the RC train wheels and axles for sale so (...) (19 years ago, 18-Aug-07, to lugnet.trains)
|
| |
| | Re: Need Electrical Help
|
|
Yes Thank you very much. This is a big help I am electrically challenged in circuits. I am trying a Microwave switch to power a train signal and track for a manually movable bridge. I will try to post it later L. Andrew Reynolds (19 years ago, 17-Aug-07, to lugnet.trains)
|
| |
| | Re: London Underground Standard Tube Stock
|
|
(...) Sock! LOL Thanks for your comments. If you look at the pic below you should be able to see the skirting (far left of pic, with a motor wheel visible under by its metallic shine). (URL) Ta, David (19 years ago, 17-Aug-07, to lugnet.trains, lugnet.loc.uk, lugnet.underground, FTX)
|
| |
| | RC/9v Train Wheel Question
|
|
I'm currently designing a set of passenger cars, and it could be very beneficial to me to be able to have my train base one plate lower than one would normally be able to have using the standard LEGO wheels. This would, of course, lead me to using (...) (19 years ago, 17-Aug-07, to lugnet.trains)
|
