 | | Re: Ability of newer 9V motors —Erik Amzallag
| | | | [snip] (...) From the same author, you will find here a good way to use the polarity switches (URL) (still in french, but reading french is not usefull to watch the pictures :) ) and the direct link for the instructions : (URL) Erik "brickerik" (...) (19 years ago, 25-Aug-05, to lugnet.trains, FTX)
| | | | | | | | | | Re: Ability of newer 9V motors —Jordan Bradford
| | | | | (...) Does that rubber band pull the switch to the off position? If so, that's pretty clever. I just put my polarity switches directly onto the train transformer on that section to the left of the dial. (19 years ago, 26-Aug-05, to lugnet.trains, FTX)
| | | | | | | | | | | | Re: Ability of newer 9V motors —Jason J. Railton
| | | | | (...) There is a much easier way - you poke an antenna or minifig round-end baton into the polarity switch, then the elastic band can go over the top of the switch, not underneath. Jason Railton (19 years ago, 26-Aug-05, to lugnet.trains, FTX)
| | | | | | |
