Subject:
|
Speed Regulator Footprint
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Mon, 11 Oct 2004 20:44:57 GMT
|
Reply-To:
|
jack_lego_maniac@diespamdie.yahoo.&Spamless&com
|
Viewed:
|
1605 times
|
| |
|
|
I was curious what the dimensions of the speed regulator are or point
me to a link or article? I'm looking for the dimension in studs, of
course, both with and without the power cord connected (if it even
matters). I didn't see anything in the Train FAQ and I couldn't find
anything in the newsgroups either, but its quite possible I overlooked
it. :)
TIA!
--Jack
AFOL, St. Louis
__________________________________
Do you Yahoo!?
Yahoo! Mail Address AutoComplete - You start. We finish.
http://promotions.yahoo.com/new_mail
|
|
Message has 1 Reply:
 | | Re: Speed Regulator Footprint
|
| (...) The front panel is 24 x 12 studs, the connector section at the back extends a further 2 studs and is 14 studs wide and overall it is about 7 bricks high. Hope this helps. ROSCO (20 years ago, 11-Oct-04, to lugnet.trains)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
