Subject:
|
control train using rcx
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Thu, 12 Feb 2004 12:25:17 GMT
|
Viewed:
|
1362 times
|
| |
|
|
Hi im currently doing a project that involves using the RCX to operate a train,
by using inertia equations. Problem is im not very experienced in using NQC
lanague. Im using potentiometers as controls on the outputs of RCX i will have
to write a program for inertia to use these controls to control the speed and
brakes of the train. On the track i shall be using the hall effect sensor this
will act as an emergency brake to stop the train before the end of the track.
Was just wondering if anyone could give me any tips on how to go about
programing this.
any help would very apprecaited
thanks
steven
|
|
Message has 1 Reply:
 | | Re: control train using rcx
|
| (...) How are you using the potentiometers on the RCX outputs? Are you using them to step down the motor voltage before it is applied to the tracks? Are you turning them by hand, or with a LEGO motor? And how are you using the hall effect device to (...) (21 years ago, 12-Feb-04, to lugnet.trains)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
