Subject:
|
Re: 4.5v upgraded to 9v - ideas welcome.
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Mon, 9 Feb 2004 18:58:24 GMT
|
Viewed:
|
1531 times
|
| |
|
|
In lugnet.trains, Dean Husby wrote:
> In lugnet.trains, Ralph Hempel wrote:
> > > Hany little thing. I'm finding it VERY useful to bring 12 volt DCC down to 9
> > > volt LEGO without losing torque.
> >
> > Just remember to limit the current through the Zener diode when dropping
> > the voltage...
> >
> > If you have a 12V supply and try to put a 9V zener without a dropping
> > resistor, it will simply burn out.
> >
> > A zener diode is really a clamping device. Better to use a standard
> > 780x liear regulator...
>
> Well yes, that goes without saying. You need to protect your DCC function output
> from exceeding it's milliamp limit. With the Zenner it just makes your
> resistance required to be far less. As an example 50 ohms as apposed to 200
> ohms.
It's probably good to say it anyway... some of us on here don't know what end of
the soldering iron to pick up (ouch! did you know soldering paste is NOT a good
burn salve?)
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: 4.5v upgraded to 9v - ideas welcome.
|
| (...) Well yes, that goes without saying. You need to protect your DCC function output from exceeding it's milliamp limit. With the Zenner it just makes your resistance required to be far less. As an example 50 ohms as apposed to 200 ohms. Dean (21 years ago, 9-Feb-04, to lugnet.trains)
|
9 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
