To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 21585
  Re: HELP! Train motors dead and dieing!
 
(...) Okay I tried measuring resistance on track 47 joints long (a broken circle) but still, the resistance is only 2-6 ohms. Then I tried running them one at a time. Even on top notch the older motor needs nudging to start on straight, has real (...) (21 years ago, 14-Nov-03, to lugnet.trains)
 
  Re: HELP! Train motors dead and dieing!
 
(...) Hi Peter! But that is only measured without electric load. Even if you have a really high resitance in the joints of the track, you still will have the 9V at any given point of the track as long as you have no parallel load on the track. A (...) (21 years ago, 14-Nov-03, to lugnet.trains)
 
  Re: HELP! Train motors dead and dieing!
 
(...) You can test this for yourself. Measure the voltage of a 9v battery with your voltmeter, then measure it again in series with a 10K resistor. It's still 9V! Now, think of all those track pieces (and joints) as tiny little resistors... :-) Mark (21 years ago, 14-Nov-03, to lugnet.trains)
 
  Re: HELP! Train motors dead and dieing!
 
(...) Peter, It sounds like the wheels are too close together and can not contact the inside of both rails of a straight. Curves are closer together for a train motor. Wheels are press fit on axles so can move. Bruce (21 years ago, 14-Nov-03, to lugnet.trains)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR