 | | Re: DCC slowing? —Mark Riley
|
| | | Perhaps the speed of the two motors was mismatched for one reason or another. This would cause the two motors to generate more heat (because they're pushing or pulling against one another) and lead to a possible overheating situation. I've read (...) (21 years ago, 13-Aug-03, to lugnet.trains)
|
| | | |
| | | | | Re: DCC slowing? —Brian B. Alano
|
| | | | Thanks for the reply, Mark. (...) Both motors had Digitrax DN121 decoders (...) I don't think the DN121 has this. (...) Both had the factory default speed tables. We ran both motors without loads (okay, 1 had a bumper on it) around the loop, and the (...) (21 years ago, 13-Aug-03, to lugnet.trains, lugnet.org.us.indylug)
|
| | | | |
| | | | | | Re: DCC slowing? —Randall Crabtree
|
| | | | "Brian B. Alano" <throwaway@insightbb.com> wrote in message news:HJKpvH.1IqC@lugnet.com... (...) over-heating. Also the bottoms of 10025 and 10022 seem to rub. I've had to replace some plates so i made them tiles... Randall Lee Crabtree (...) (21 years ago, 14-Aug-03, to lugnet.trains, lugnet.org.us.indylug)
|
| | | | |
