Subject:
|
Re: Orientation of single train buffers
|
Newsgroups:
|
lugnet.cad, lugnet.trains
|
Date:
|
Tue, 17 Jun 2003 09:54:09 GMT
|
Viewed:
|
280 times
|
| |
|
|
In lugnet.cad, Niels Karsdorp wrote:
> I am about to create the single train buffers into LDraw.
> What orientation shall I use, e.g. where to put the buffer:
> * -X (left)
> * +X (right)
> * -Z (front)
> * +Z (rear)
> I thought about putting the origin between the two studs.
>
> Niels
Just to avoid any misunderstandings: Is the bumper at the front?
/Tore
|
|
Message has 2 Replies:
 | | Re: Orientation of single train buffers
|
| Hej Niels, I only just began creating parts myself, but here's my thoughts. The origin between the studs sounds oki, that'd make snapping it to the grid much easier. On what side the buffer is, is not that important I think. Perhaps there is some (...) (21 years ago, 17-Jun-03, to lugnet.cad, lugnet.trains)
|
Message is in Reply To:
| | Orientation of single train buffers
|
| I am about to create the single train buffers into LDraw. What orientation shall I use, e.g. where to put the buffer: * -X (left) * +X (right) * -Z (front) * +Z (rear) I thought about putting the origin between the two studs. Niels (21 years ago, 17-Jun-03, to lugnet.cad, lugnet.trains)
|
5 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
