 | | Re: Round parts on the side of ... (was Re: LEGO SW Haildire Droid will cost....
|
|
(...) personaly i dont think they will be large enough to build a rotary. this is mainly because the center point of the rotation gear is also in the same position as the couplers. this is at least in modern rotary dumps. a good solution might be to (...) (22 years ago, 6-Jan-03, to lugnet.trains)
|
| |
| | Re: Round parts on the side of ... (was Re: LEGO SW Haildire Droid will cost....
|
|
(...) If it's round and made out of LEGO, it doesn't matter if the gear teeth mesh or not. The big problem with rotary dumps till now has been what is it that you rotate? till now nothing has been both large enough and round enough. Once you have (...) (22 years ago, 6-Jan-03, to lugnet.trains)
|
| |
| | Re: GG-1 Model Complete
|
|
Very nice. I would love to see how you have the inner trucks configured. They would almost have to be floating to make it around curves. -Rob "Bob Hayes" <bobhayes1@aol.com> wrote in message news:H882K7.Ao7@lugnet.com... (...) I (...) (22 years ago, 6-Jan-03, to lugnet.trains)
|
| |
| | Re: Round parts on the side of ... (was Re: LEGO SW Haildire Droid will cost....
|
|
Here is what I've calculated on this new component "gear wheel" (my calculations could be MILES off of correct, mind you): -Teeth count is approximately 96 on the outside. -Outside diameter is 24 studs -Inside diameter is 20 studs -The strip running (...) (22 years ago, 6-Jan-03, to lugnet.trains)
|
| |
| | Re: 2003 Trains - great!
|
|
(...) no its not you.. lego made to many for star wars. now all those starfighter windshields have to look nice on modern euro freight :) but the fact that its tinded windshields could make use if they ever got a liscence with universal for "fast (...) (22 years ago, 6-Jan-03, to lugnet.trains)
|
