To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 18156
  Re: a trick to make NEW trainwheels work - PICTURE SERIE
 
(...) ... I tried. For step 2, I used one #3673 Technic Pin and two cut-up part #3749 (Technic, Axle Pin). The middle rib isn't quite as wide, and it made it easier not to push it in too far (and I have more of them.) I found that after step 3, it (...) (22 years ago, 24-Oct-02, to lugnet.trains, lugnet.lego.direct)
 
  Re: a trick to make NEW trainwheels work - PICTURE SERIE
 
(...) This is exactly what you must NOT do! Don't push it down, the axle must push the pin UP... Goal is NOT to press the axle down, goal is to use the 'snap-hight' of the axle-end as a 0,6 mm filler for the (too much) space in this new molds. After (...) (22 years ago, 25-Oct-02, to lugnet.trains, lugnet.lego.direct)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR