 | | Re: Motorized Switch
|
| (...) Well, some good, some bad. The good is that leaving the motor going in one direction for 20 minutes causes no separations and no apparent stress to any parts. The bad is that it did overheat the motor, which wouldn't run again until it cooled (...) (22 years ago, 7-Jun-02, to lugnet.trains, lugnet.technic)
| | | | | Re: Motorized Switch
|
| <SNIP> troubleshooting time on this assembly. (...) Will you be posting a new .mpd file to your brickshelf account showing the changes? BTW the othe .mpd file was *not* right. What I mean by that is that usually when one creates a .mpd file the (...) (22 years ago, 7-Jun-02, to lugnet.trains, lugnet.technic)
| | | | | Re: Motorized Switch
|
| (...) Yes, I'll update it tomorrow; I don't have MLCAD installed at home. Sorry about the poor .mpd; this is not just my first motorized switch, it's my first time using MCLAD. :) (...) Thanks! I owe a lot to other people who have done these in the (...) (22 years ago, 7-Jun-02, to lugnet.trains, lugnet.technic)
| | | | | Re: Motorized Switch
|
| (...) 20 minutes?!?! Yikes! I've stalled my motors often, but only for a few seconds. I imagined that would be the same situation for your switch. Leaving it on for 20 min- you're boldly going where no Technic-head has gone before... ;-) TJ p.s. I (...) (22 years ago, 7-Jun-02, to lugnet.trains, lugnet.technic)
| | | | | Re: Motorized Switch
|
| (...) The instructions are updated: (URL) moved the completed model back to the top of the .mpd, although that makes the instructions feel backwards to me. thanks, James (22 years ago, 7-Jun-02, to lugnet.trains, lugnet.technic)
| | | | | Re: Motorized Switch
|
| (...) I've had a couple people say that now. :) (...) Normally the switch won't even have it stalled for a few seconds; it takes less than a second of power to flip the switch over. Just tapping the button isn't *quite* enough time, but it's not (...) (22 years ago, 7-Jun-02, to lugnet.trains, lugnet.technic)
| |
