Subject:
|
Re: My Cable Car (Trolley)
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Fri, 18 May 2001 07:27:08 GMT
|
Viewed:
|
364 times
|
| |
|
|
On his personal webside, Dean Husby writes:
> The challenge arose when it came time to attach the 9 V motor to the base. >The 9 V motor has a large stem protruding from the top. This forced me to >raise the entire model to accommodate this stem.
Have you tried to compose the floor out of some 2 stud width plates, with
one of the Technic Plate with Holes in the center. This last part would take
the stem from the 9 V motor in a not too obvious manner, eleminating the
need to raise the floor.
Greetings, M. Moolhuysen.
|
|
Message has 1 Reply:
 | | Re: My Cable Car (Trolley)
|
| (...) Thanks for the advice, I plan to revisit all that area once my brown stock has had a chance to regenerate. ;) My thoughts were to do as you suggest and that the peg would fit between the two chairs. Dean -- Coin-Op's For Sale!: (URL) Lego (...) (23 years ago, 18-May-01, to lugnet.trains)
|
Message is in Reply To:
| | My Cable Car (Trolley)
|
| I've finally put up the pictures of my Cable Car that I did last year... (URL) For Sale!: (URL) Lego Workshop: (URL) Lego Club: (URL) (23 years ago, 17-May-01, to lugnet.trains)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
