 | | Re: ME Models Metal Rails
|
|
(...) I'm not sure if I fully understand your question here, but I do have the additional geometry available for use in track draw, meaning, I should be able to convert it to BlueBrick (but I haven't played with it much). (...) I should be able to (...) (13 years ago, 3-Apr-11, to lugnet.trains)
|
| |
| | Re: ME Models Metal Rails
|
|
(...) when using CAD based track designers like Bluebrick? The full, half and quarter lengths of both the straight and curved tracks? Does the future also include renditions of the switches are crossings? (13 years ago, 3-Apr-11, to lugnet.trains)
|
| |
| | Re: ME Models Metal Rails
|
|
(...) I have a sample and the edges, while crisp rather than rounded, are not sharp enough to cut. There may be a bit more wear due to the metal corner, not sure. But I'm not too worried about that. The adapter piece is a little less shiny than (...) (13 years ago, 2-Apr-11, to lugnet.trains)
|
| |
| | Re: ME Models Metal Rails
|
|
(...) Our manufacturer of the rails runs the rail through a "de-burrer" machine. Basically there is a wash and bunch of ceramic stones. The unit vibrates and a unique smooth finish comes about when each rail comes out of the bath. There are no sharp (...) (13 years ago, 1-Apr-11, to lugnet.trains)
|
| |
| | Re: ME Models Metal Rails
|
|
(...) make this announcement... Neat system, but I have a concern that the plastic wheels against the sharp inside edge of the rail will wear down the wheels faster than usual. If I buy some, I might have to round off the top of the rails just a (...) (13 years ago, 1-Apr-11, to lugnet.trains)
|
