 | | My Train Yard...
|
|
(URL) (16 years ago, 21-Sep-08, to lugnet.trains, FTX)
|
| |
| | Re: Is there a reference site on motorized switchs
|
|
(...) Try these. There is some good information on all of them. (URL) FreeLUG Article on Motorized Points> (URL) Automated 9V Switch> (URL) Mark Riley's Solution> Good luck and happy building! -Dave ToT-LUG (16 years ago, 18-Sep-08, to lugnet.trains, FTX)
|
| |
| | Is there a reference site on motorized switchs
|
|
I thought I had found one once, but then seem to have lost track of it, HELP!! (16 years ago, 18-Sep-08, to lugnet.trains)
|
| |
| | Re: Automated Level Crossing using NXT
|
|
quite neat. I hope you can figure out the correct switching delays for the micromotor. Do you think this technique could be used to make a monorail level crossing ? Steve (16 years ago, 11-Sep-08, to lugnet.trains, FTX)
|
| |
| | ATSF Piggy-Back Service (Flatbed w/Truck Trailer) MOC
|
|
Here's my latest train MOC. This is an ATSF Piggy-Back Service train... (2 URLs) Here's the model it was based on: (URL) Mark (16 years ago, 9-Sep-08, to lugnet.trains, FTX)
|
| |
| | New Red Chemical Car
|
|
I managed to snag some rare dark red brick from a grab bag at the local Lego store. The dark red pieces are from set 7665 (Republic Cruiser). I then combined them with some extra train parts and you get what you see below. The end result was this (...) (16 years ago, 9-Sep-08, to lugnet.trains, FTX)
|
| |
| | Re: Automated Level Crossing using NXT
|
|
That is an excellent system for controlling train crossings. I love that it is all above the baseplates and only uses one motor for both crossings. I have two suggestions for the motor timing on raising and lowering of the gates: 1) Use a Technic (...) (16 years ago, 6-Sep-08, to lugnet.trains)
|
| |
| | Re: Trains, Car and Level Crossing Automatic Control System
|
|
(URL) (16 years ago, 6-Sep-08, to lugnet.trains, FTX)
|
| |
| | Trains, Car and Level Crossing Automatic Control System
|
|
This system is used 4 RCXs to control 2 trains, 1 car and 1 level crossing. RCX1 is used to control 3 switch points and response 3 light sensors. RCX2 is used to control 3 segments track and response 2 light sensors. RCX3 is used to control level (...) (16 years ago, 6-Sep-08, to lugnet.announce.moc, lugnet.trains, lugnet.robotics.rcx.legos) !
|
| |
| | Re: Automated Level Crossing using NXT
|
|
(...) break at some point, but you seem to have a pretty good system there. (...) Actually, I think you could do this at least partially with a single sensor. If the train is running at a fixed speed, you can have the program figure that speed out (...) (16 years ago, 5-Sep-08, to lugnet.trains, lugnet.robotics.nxt)
|
