| | Re: Steam Drivers by Big Ben Bricks!!!
|
|
(...) I think it's enough so that, with the addition of the width of half the ridge around a pin, it'll stand clear. Fitting a round plate on the hub, if it clears the end of the axle, would just foul the connecting rod anyway. I think these are (...) (21 years ago, 8-Nov-03, to lugnet.trains)
|
|
| | Re: Steam Drivers by Big Ben Bricks!!!
|
|
(...) Can't speak for the other colors but I think the black matches VERY closely. I like the feel of the plastic too, and there's very little flash too. Sign of good tooling if you ask me! (21 years ago, 8-Nov-03, to lugnet.trains)
|
|
| | Re: Steam Drivers by Big Ben Bricks!!!
|
|
(...) My guesses are that this tooling has been under development for some time, certainly well before Ben's analysis was posted... so these ideas were not known at the time of development. Redoing tooling at this point will add a lot of cost, I (...) (21 years ago, 8-Nov-03, to lugnet.trains)
|
|
| | Re: Steam Drivers by Big Ben Bricks!!!
|
|
"Jonathan Wilson" <jonwil@tpgi.com.au> wrote in message news:Ho0K74.CrC@lugnet.com... (...) Ben's Driver Wheels are now posted as a ILTCO Sneak Peek! (URL) Mike Walsh - mike_walsh at mindspring.com (URL) - North Carolina LEGO Train Club (URL) - (...) (21 years ago, 8-Nov-03, to lugnet.trains)
|
|
| | Re: 48 x 48 baseplate + Train Track + Race Track
|
|
(...) That someone was Kevin Loch and other participants at a meeting of the WamaLTC earlier this year. Abe Friedman's photograph of the result: (URL) (21 years ago, 8-Nov-03, to lugnet.trains, lugnet.space)
|