 | | Re: Redesigned Intermodal Car
|
|
(...) Have you tried not using the power leads at all? I haven't tried it, but it would seem that if you cut a 'normal' 9volt wire, split the end and strip a short section of wire -- you could pry up the metal part of a rail enough to slip the wire (...) (21 years ago, 17-Jun-03, to lugnet.trains, FTX)
|
| |
| | Re: Redesigned Intermodal Car
|
|
John, these are absoulutely awesome. But FOUR Maersk conatainers?!?! :^p I like especially the use of the technic bars for the bracing, it nails the effect. And the bettendorf trucks look nice. -Stefan- (...) (21 years ago, 17-Jun-03, to lugnet.trains, FTX)
|
| |
| | Re: Orientation of single train buffers
|
|
(...) Hello Niels, The buffer plate (the part that comes in contact with the buffer of another wagon) should pont towards the -Z direction, because this is consistent with existing official part #4022 Train Buffer Beam (see picture): [LDrawPart (...) (21 years ago, 17-Jun-03, to lugnet.cad, lugnet.trains, FTX)
|
| |
| | Re: Orientation of single train buffers
|
|
(...) That's what I'm just asking the community. Where should I put the buffer or bumper (or how it should be called in English ;-P ) (21 years ago, 17-Jun-03, to lugnet.cad, lugnet.trains)
|
| |
| | Re: Orientation of single train buffers
|
|
Hej Niels, I only just began creating parts myself, but here's my thoughts. The origin between the studs sounds oki, that'd make snapping it to the grid much easier. On what side the buffer is, is not that important I think. Perhaps there is some (...) (21 years ago, 17-Jun-03, to lugnet.cad, lugnet.trains)
|
