 | | Re: An updated reciprocal point motor design with semaphore
|
|
(...) You bet - I'm working on an LDraw model of it, and I'll post when it's ready. Thanks, Ed (23 years ago, 28-Mar-02, to lugnet.trains)
|
| |
| | Re: wheelset ideas
|
|
(...) Hi Chris, I have done a solution for this a while ago, because I needed red sideframes: (URL) used the tube from for e.g. 7171 (or flex-system) to connect the frame. But you might get into trouble with your height problem again if you doit the (...) (23 years ago, 28-Mar-02, to lugnet.trains)
|
| |
| | Re: Nice double stack container cars!!!!
|
|
So far they run well through the curves but I havent had a chance to try them through switches. There doesnt seem to be any interference with the laders. And I belive they tend to run the container cars in groups of 3's and 5's. Now I dont know if (...) (23 years ago, 28-Mar-02, to lugnet.trains)
|
| |
| | Re: wheelset ideas
|
|
(...) Well, they *all* are for that matter! My kingdom for a bettendorf-styled truck from TLC! (and Blomberg sidebars for the motors, too:-) (...) Trock Trick! The only way to identify its 8wideness was to observe the 6 wide semi-trailer, and even (...) (23 years ago, 28-Mar-02, to lugnet.trains)
|
| |
| | Re: An updated reciprocal point motor design with semaphore
|
|
<snip explanation of motor design> (...) Would it be too much to ask for a LDRAW model of this wonderful point for those of use with very little 'train design' experince? Thanks! AHui (23 years ago, 28-Mar-02, to lugnet.trains)
|
