Subject:
|
Re: Lego® Technic Motor (43362) internals
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Wed, 11 Dec 2002 19:35:45 GMT
|
Viewed:
|
5489 times
|
| |
|
|
Indeed, I see no technical or dimensions problems that would prevent using a
hole. But perhaps that was not possible in 71427 - and compatibility rules !!!
Philo
In lugnet.technic, Brian B. Alano writes:
> Thanks for the sacrifice!
A small one, it works fine now!
>
> From what I can see, it looks like there's room in this motor for an
> axle *hole* rather than an axle shaft. What a shame...
>
|
|
Message has 1 Reply:
 | | Re: Lego® Technic Motor (43362) internals
|
| (...) I think it should have been possible there as well (I have a disassembled 71427 that was broken). As for compatibility, if you put an axle 2 into the hole it should be pretty much equivalent, maybe not as strong mechanically. Another question (...) (22 years ago, 12-Dec-02, to lugnet.technic)
|
Message is in Reply To:
11 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
