 | | Re: Lego® Technic Motor (43362) internals
|
|
Thanks for the sacrifice! From what I can see, it looks like there's room in this motor for an axle *hole* rather than an axle shaft. What a shame... (...) (22 years ago, 11-Dec-02, to lugnet.technic)
|
| |
| | Re: Lego® Technic Motor (43362) internals
|
|
Indeed, I see no technical or dimensions problems that would prevent using a hole. But perhaps that was not possible in 71427 - and compatibility rules !!! Philo (...) A small one, it works fine now! (...) (22 years ago, 11-Dec-02, to lugnet.technic)
|
| |
| | Re: Lego® Technic Motor (43362) internals
|
|
(...) It should be fairly easy to saw off the axle and glue a bush to the shortened axle, thus getting an axlehole instead of the protruding pin. The mainproblems would be to - Get the bound strong - Get the bush centered on the axle Perhpas some (...) (22 years ago, 12-Dec-02, to lugnet.technic)
|
| |
| | Re: Lego® Technic Motor (43362) internals
|
|
(...) I think it should have been possible there as well (I have a disassembled 71427 that was broken). As for compatibility, if you put an axle 2 into the hole it should be pretty much equivalent, maybe not as strong mechanically. Another question (...) (22 years ago, 12-Dec-02, to lugnet.technic)
|
| |
| | Re: Lego® Technic Motor (43362) int ernals
|
|
(...) Notoriously difficult (...) I'd rather use a hacksaw on a technic angle or axle connector. (...) Probably not so easily. (...) I'd rather propose the following operation (totally theoretic, use at your own risk): Saw of the protruding axle and (...) (22 years ago, 12-Dec-02, to lugnet.technic)
|
