 | | Strange anomalies in 8460 and 8868...
|
|
I was just looking around at various pictures of the 8460 (Pneumatic Crane Truck) and 8868 (Airtech Claw Rig) sets, and noticed a few strange things... All the pictures I have seen of 8460 (including the box and Brickshelf scan) appear to have the (...) (25 years ago, 5-Dec-00, to lugnet.technic)
|
| |
| | Strange anomalies in 8460 and 8868...
|
|
I was just looking around at various pictures of the 8460 (Pneumatic Crane Truck) and 8868 (Airtech Claw Rig) sets, and noticed a few strange things... All the pictures I have seen of 8460 (including the box and Brickshelf scan) appear to have the (...) (25 years ago, 5-Dec-00, to lugnet.technic)
|
| |
| | Does anyone have the Comborider instructions?
|
|
I want the instructions for the big RoboRiders, but they can apparently no longer be found at lego.com. I tried to load the smaller riders, but they are all one big error. Are these on brickshelf or anything? (25 years ago, 5-Dec-00, to lugnet.general, lugnet.technic, lugnet.build)
|
| |
| | Re: 8457 Power Puller
|
|
I have build 2 of these machines, this is a nice set, but I have a two complaints about this set. 1. the flex stearing system does not respond good. 2. the mechanisme to transfer the motor to the wheels is a sloppy, there are 5 chains with each 16 (...) (25 years ago, 4-Dec-00, to lugnet.technic)
|
| |
| | Re: Gear train friction?
|
|
Amnon, I've also found a not in-significant source of friction is the bushes against the beams (or whatever your axle goes through). I've reduced this a bit on occasion by not using bushes to hold axles in position, but having a brick at each end, (...) (25 years ago, 4-Dec-00, to lugnet.technic)
|
