Subject:
|
8880 Supercar
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Mon, 22 Nov 1999 15:20:50 GMT
|
Viewed:
|
599 times
|
| |
|
|
I'm putting together the 8880 supercar at the moment and I've run into
something that I can't figure out.
On the rear wheel steering, when I connected up the crossmember steering
dealy, it's too short. I've re-looked over the whole steps on the rear
section and don't see anything.
But now, with the steering crossmember connected when one wheel is straight
the other is at about a 45 degree angle. IT doesn't do this on the front.
Any ideas?
|
|
Message has 1 Reply:
 | | Re: 8880 Supercar
|
| (...) The front and rear steering cross-member plates should be of the same length. Grahame Reid (25 years ago, 26-Nov-99, to lugnet.technic)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
