 | | Re: Chain Precession Drive - Courtesy of TechnicBRICKs
|
|
Owen and Mike, The 2825 part connects the input shift with the orbiter. The part that was shown in the original LDRAW model clearly does not work because all its holes are round and so there is no way of transferring torque to the orbiter body. The (...) (16 years ago, 23-Mar-09, to lugnet.technic)
|
| |
| | Re: Chain Precession Drive - Courtesy of TechnicBRICKs
|
|
(...) Apologies for not having part numbers to hand.. You did mean the 1x5 not the 1x4 liftarm? if so Owen is right the cog must turn freely hence the excessive 1x5 liftarm. I would be interested to see if you have a working redesign... If you meant (...) (16 years ago, 23-Mar-09, to lugnet.technic)
|
| |
| | Re: Chain Precession Drive - Courtesy of TechnicBRICKs
|
|
(...) Bill. Perhaps you could elaborate on that a little? I can't see that part working there at all - the 2825 part has crosses at both ends, and you need the axle attached to the gear to be able to rotate freely. Owen. (16 years ago, 23-Mar-09, to lugnet.technic)
|
| |
| | Re: Chain Precession Drive - Courtesy of TechnicBRICKs
|
|
(...) It is indeed a noteworthy invention. Please note, however, that the DAT file linked to from the web page has an error: you need to substitute part 2825.dat (Technic liftarm 1x4 with boss) for the part 32017.dat (Technic liftarm 1x5) that is (...) (16 years ago, 22-Mar-09, to lugnet.technic)
|
| |
| | Re: A couple of gear questions
|
|
(...) No, it is not really a gear. You might be able to get two of them to mesh, but I wouldn't recommend it. It is used on the Code Pilot (and elsewhere) to measure rotation speed along with a light. (...) The 24 tooth clutch is a torque limiter. (...) (16 years ago, 9-Mar-09, to lugnet.technic, FTX)
|
