To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 16292 (-10)
  Re: New Crane...
 
(...) That's a lot of cranes. Are they all yours? (...) I know I'd like to know. Steve (17 years ago, 22-Feb-08, to lugnet.technic)
 
  Re: New Crane...
 
(...) It worked pretty well for me on this one: (URL) all of these: (URL) have had no problems with the two parts coming apart....If you can tell by this pic, the red and white one is holding up a 8421 almost 8 feet away from the center of (...) (17 years ago, 22-Feb-08, to lugnet.technic)
 
  Re: New Crane...
 
(...) Thanks, read about it (URL) here>. ROSCO (17 years ago, 21-Feb-08, to lugnet.technic, FTX)
 
  Re: New Crane...
 
(...) Great crane Rosco, shame their's no accompanying text. Steve (17 years ago, 21-Feb-08, to lugnet.technic, FTX)
 
  Re: New Crane...
 
(...) Yes, that is correct. (...) See also (URL) technique> - this allowed me to lift the whole crane base up by the superstructure. ROSCO (17 years ago, 21-Feb-08, to lugnet.technic, FTX)
 
  Re: New Crane...
 
(...) Mine has that. (17 years ago, 21-Feb-08, to lugnet.technic)
 
  Re: Technicopedia Update
 
I have to say that's an absolutely amazing site! Fascinating stuff, I have it bookmarked and I'm looking forward to the rest of your updates! :-) (17 years ago, 21-Feb-08, to lugnet.technic)
 
  Re: New Crane...
 
(...) This is correct. Real cranes have roller bearings that are pinned in place that bear the weight and force of the superstructure where it is connected to the base. (...) I am going to use a threaded axle through the center to hold the plates (...) (17 years ago, 21-Feb-08, to lugnet.technic)
 
  What should happen with the lugnet.robotics.nxt sidebar?
 
Hello, LUGNET readers. In case you don't know, I'm the lugnet.robotics.nxt curator. I used to update the NXT section sidebar with [in]frequent regularity, but during the last couple months I've not done anything to it. I get busy and/or don't take (...) (17 years ago, 21-Feb-08, to lugnet.robotics.nxt, lugnet.technic, lugnet.general, lugnet.admin.curators)  
 
  Re: Linear Actuator
 
(...) Obviously with *my* interests, I hope that the linear actuator is not the end of pneumatics. There are still a lot of ideas I've not had a chance to try, but more part type options are great! Kevin (www.kclague.net) (17 years ago, 21-Feb-08, to lugnet.technic)


Next Page:  5 more | 10 more | 20 more

Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR