|
|
 | | Re: motor disassembly
|
| (...) I bought a Znap set on eBay (my first!) and it also has an older 71427 motor that doesn't turn well. It works when powered but I don't think it's very happy. I, too, would like to know what I can do to get this motor to float the way it's (...) (18 years ago, 9-Feb-07, to lugnet.robotics, lugnet.technic)
| | | | | Re: R/C skid steer test
|
| (...) Hi Rob, You might consider using the auxilary output of the RC to control a gear shifter to select between "driveable" and "mad spining" modes... Using the polarity switch is brilliant! I tried a pure mechanical solution (the steering (...) (18 years ago, 9-Feb-07, to lugnet.org.ca.rtltoronto, lugnet.technic)
| | | | | Re: R/C skid steer test
|
| (...) Oh yes! it can steer when going forward. With the current gearing though, it spins out. I should try to drive the adder/subtractor input with an 8-tooth gear rather than the current 24 to slow the turning rate down. Though I suppose I couldn't (...) (18 years ago, 7-Feb-07, to lugnet.org.ca.rtltoronto, lugnet.technic)
| | | | | Re: R/C skid steer test
|
| (...) Nice! Can it steer while also moving forward, or does the switch work with just a 3-position action (turn right/go straight/turn left)? Could you also use 3 12-tooth gears for the side opposite the 2 24-tooth gears, or did you use the 2 (...) (18 years ago, 6-Feb-07, to lugnet.org.ca.rtltoronto, lugnet.technic)
| | | | | Re: Mechanical obstacle avoider 2
|
| "Alexander Holroyd" <holroyd@shaw.ca> wrote in message news:JD16LC.Bos@lugnet.com... (...) That is just excellent! Thanks for sharing it. Bob (18 years ago, 6-Feb-07, to lugnet.technic)
|
|
