| |
In lugnet.org.ca.rtltoronto, Rob Antonishen wrote:
>
> Oh yes! it can steer when going forward. With the current gearing
> though, it spins out. I should try to drive the adder/subtractor
> input with an 8-tooth gear rather than the current 24 to slow the
> turning rate down. Though I suppose I couldn't spin madly in place
> then :)
>
>
> -Rob A>
Hi Rob,
You might consider using the auxilary output of the RC to control a gear shifter
to select between "driveable" and "mad spining" modes...
Using the polarity switch is brilliant! I tried a pure mechanical solution (the
steering mechanism would brake one side or the other) before but with
unconvincing results... Maybe I should give it another try.
Greetings,
David
|
|
Message is in Reply To:
 | | Re: R/C skid steer test
|
| (...) Oh yes! it can steer when going forward. With the current gearing though, it spins out. I should try to drive the adder/subtractor input with an 8-tooth gear rather than the current 24 to slow the turning rate down. Though I suppose I couldn't (...) (18 years ago, 7-Feb-07, to lugnet.org.ca.rtltoronto, lugnet.technic)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
