 | | Re: Need to figure out how to get this motor unit attached. —Chris Orchard
|
| | | (...) Hi Geoffrey, I think the easiest way to turn gearing through use of the worm gear, however as others will point out a worm gear is not very efficient gearing down mechanism, also if this is run for several hours at a time, the meshed gears (...) (19 years ago, 19-Apr-06, to lugnet.technic)
|
| | | |
| | | | | Re: Need to figure out how to get this motor unit attached. —Geoffrey Hyde
|
| | | | "Chris Orchard" <chris_orchard@+Remo...es.com.au> wrote in message news:Ixy4C6.CyI@lugnet.com... (...) The worm gear pics that I loaded into the folder recently are for a one-way worm gear drive. This basically is so I can set the hopper on and (...) (19 years ago, 19-Apr-06, to lugnet.technic)
|
| | | | |
| | | | | | Re: Need to figure out how to get this motor unit attached. —Chris Orchard
|
| | | | (...) One-way can also be done with an gear on the pivot of an arm meshing with an idler gear on the end that swings between two close gears. You wouldn't have to go through any 90 deg twists then. :P (...) I could be wrong, but I thought that the (...) (19 years ago, 19-Apr-06, to lugnet.technic)
|
| | | | |
| | | | | | Re: Need to figure out how to get this motor unit attached. —Geoffrey Hyde
|
| | | | "Chris Orchard" <chris_orchard@+Remo...es.com.au> wrote in message news:Ixyn0n.230B@lugnet.com... (...) First up, something about the quotation style seems to be getting screwed up, I normally separate out different levels of quotation to mark them (...) (19 years ago, 19-Apr-06, to lugnet.technic)
|
| | | | |
