|
|
 | | Re: Technic prop
|
| (...) I'm intending to build a plane of WWII vintage although I'm not saying which one yet as that would spoil the surprise. I'm going to build it to scale which is why I need the accurate figure. The rest of the plane is going to be built in the (...) (19 years ago, 22-Dec-05, to lugnet.technic)
| | | | | Re: Technic prop
|
| (...) Hi Steve, First I tried measuring its radius but this is not an easy task as the center point and the tip of the blades are on different planes. It looked like slightly less than 60mm but I could not tell for sure. So I built the test rig (...) (19 years ago, 22-Dec-05, to lugnet.technic)
| | | | | Re: Technic prop
|
| (...) Did you actually measure it or is that a guestimate? cause I need an accurate figure. Thanks Steve (19 years ago, 22-Dec-05, to lugnet.technic)
| | | | | Re: Technic prop
|
| (...) blade length to center of prop appears to be about 60mm/2.5" hope that helps (19 years ago, 22-Dec-05, to lugnet.technic)
| | | | | Re: Worm Gear Problem
|
| (...) Hi Eric, I actually intended that the inherent backlash in the z16s was exploited to turn them in a little after the positioning. You could replace my z16s with two z24s and a z8, making one of the z24s a clutch gear so you could turn them (...) (19 years ago, 22-Dec-05, to lugnet.build.mecha, lugnet.technic)
|
|
