Subject:
|
Re: High Failure Rate of New Type 9V Geared Motor
|
Newsgroups:
|
lugnet.robotics, lugnet.technic
|
Date:
|
Fri, 21 Oct 2005 20:29:16 GMT
|
Viewed:
|
1245 times
|
| |
|
|
In lugnet.robotics, Chio Siong Soh wrote:
> In lugnet.robotics, Nathan Bell wrote:
> > In lugnet.robotics, Chio Siong Soh wrote:
> > > Bad tidings! I'm experiencing a rather high failure rate with the new type 9V
> > > geared motor (#43362). This motor has been discussed before
> > > (http://news.lugnet.com/robotics/?n=19204&t=i&v=a)
> >
> > I had the same problem with one of mine. Using them in a fast RC car might do
> > this if it gets slammed into something. I will inform Nathanael Kuipers of the
> > problem since he works at TLC and can tell the proper person.
>
> Thanks!
> No, these motors were only used for FLL type challenges, not in fast RC cars.
>
> I can submit the bad motors for *CSI* and 'autopsy' if need be.
>
> C S Soh
I sent Nathanael Kuipers an email regarding the motors and asked him to forward
it to the proper person.
Do you think it is excessive torque, excessive use, or just a bad piece design
that causes this problem?
Nathan
|
|
Message has 1 Reply:
Message is in Reply To:
8 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
