| | Re: High Failure Rate of New Type 9V Geared Motor
|
|
(...) I had the same problem with one of mine. Using them in a fast RC car might do this if it gets slammed into something. I will inform Nathanael Kuipers of the problem since he works at TLC and can tell the proper person. (19 years ago, 17-Oct-05, to lugnet.robotics, lugnet.technic)
|
|
| | Re: Road Grader
|
|
(...) Hi Vineet! The model is 80% done and I have run out of yellow studs. Here is Saturday's link- (URL) may decide to make it with a black stripe down the side which would utilize the large supply of black studs I have. Since I never make (...) (19 years ago, 17-Oct-05, to lugnet.technic)
|
|
| | Crane MOC made during boredom
|
|
Hey all, thought I'd share my little crane MOC. It's a custom base with two new 9v geared motors used to drive each track through the following gears: 24 tooth crown on motor 24 tooth 8 tooth 8 tooth 24 tooth 8 tooth 24 tooth 40 tooth driving treads (...) (19 years ago, 17-Oct-05, to lugnet.technic)
|
|
| | High Failure Rate of New Type 9V Geared Motor
|
|
Bad tidings! I'm experiencing a rather high failure rate with the new type 9V geared motor (#43362). This motor has been discussed before ((URL) motor can be easily recognised: when you twirl the shaft it turns very little and quickly comes to a (...) (19 years ago, 17-Oct-05, to lugnet.robotics, lugnet.technic)
|
|
| | Re: Road Grader
|
|
Nate- Compliments go out to the design of the grader! I like the way you used the pneumatics in the front steering (I guess I was wrong about the length of the piston arm!). On your other creation, the road scraper, do you also plan to use (...) (19 years ago, 16-Oct-05, to lugnet.technic)
|