 | | Re: Technic question: how to connect 2 technic beams
|
|
(...) Do the two beams need to be studded? Bracing two studless beams could be a lot easier, not as high either. If you can show us what you are trying to fit this into, I'm sure someone here will come up with the solution. :) Cheers, Chris. (19 years ago, 6-Oct-05, to lugnet.technic)
|
| |
| | Re: Hex565 - one leg at at time pneumatic hexapod
|
|
(...) That is a joy to watch. Even if it is slower than some other gait, it is very interesting to watch. I have vaguely followed your pneumatic threads, watching the cool diagrams and devices, but I will admit you lost me a while back with this. (...) (19 years ago, 5-Oct-05, to lugnet.technic, lugnet.robotics)
|
| |
| | Re: Technic question: how to connect 2 technic beams
|
|
(...) How many studs of overlap can you have? Also, how much space can you have on the sides? A tacky way to solve the problem would be to run a string through the holes in a spiral type fasion and then tie the ends together. Hey; no one can say it (...) (19 years ago, 5-Oct-05, to lugnet.technic, FTX)
|
| |
| | Re: Technic question: how to connect 2 technic beams
|
|
(...) You could try a cam with an offset of 1 hole sideways along the beams - the distance between the offset holes is about 1.5L (12mm). Use the hole in the middle of the large end of the cam as well as the hole at the small end. You probably need (...) (19 years ago, 5-Oct-05, to lugnet.technic, FTX)
|
| |
| | Re: Technic question: how to connect 2 technic beams
|
|
(...) Thanks for the ideas... however I am constrained to a height of 2 beams. This height restriction is what is causing me grief as I can not space the beams or add above/below to use the liftarms. Jeff (19 years ago, 5-Oct-05, to lugnet.technic, FTX)
|
