|
|
 | | Re: Pneumatic Arm
|
| (...) That construction would be fine if the "beams" are always in compression, but because the diagonals all slope the same way in each section, it would be prone to twisting failure if you're not careful. ROSCO (20 years ago, 15-Dec-04, to lugnet.technic)
| | | | | Re: Pneumatic Arm
|
| (...) <snip for bandwidth> (...) My answers to Technic Towers O' Power and Orthogonal Bracing: Method 1- Axles, Axle Connectors and Studless: 1 square segment = 4x Constructed as follows Verticals using Axle Connector #2 Alternating 90 degrees with (...) (20 years ago, 15-Dec-04, to lugnet.technic)
| | | | | Re: Ferrari
|
| (...) I have his email and could ask him if it is a hoax if you wish. Why is it not on the lego website? I have no idea where he found the picture. Does anyone else? (20 years ago, 15-Dec-04, to lugnet.technic)
| | | | | Re: large technic hook
|
| (...) You mean the one that is on the wirlwind rescue? I believe that it might be Aluminum, Because of how light it is. Aluminum will not rust from water. As for paint, I have no idea. I scratched a little bit off with a knife, So it might be (...) (20 years ago, 15-Dec-04, to lugnet.technic)
| | | | | large technic hook
|
| Does anyone know what metal the large technic hook is made from? Or what coating (paint etc) is applied? Is it waterproof (i.e. will it rust if I get it wet?) (20 years ago, 15-Dec-04, to lugnet.technic)
|
|
