 | | Re: SSClagorpion
|
| (...) It was a joke Steve...... Gotta get those studless beam haters some stimuli. Studded beams make a lot of sense in the body, because of their superior strenght. (...) Patience Steve. I spent *all* day yesterday and this morning getting this (...) (21 years ago, 9-May-04, to lugnet.technic)
| | | | | Re: SSClagorpion
|
| (...) I wasn't sure if you were on some studless-beam kick... :) I think the body needs to be wider, for scale. (...) I know this takes time. (...) I was thinking about the leg lock & pistion that you set-up. -- I came up with an arm design. I (...) (21 years ago, 9-May-04, to lugnet.technic)
| | | | | Re: SSClagorpion
|
| (...) I tend to build with studless parts unless studs are needed, but in this case we don't need the studs, but will need the strength (and parts with the right number of holes). (...) Is there an echo in here? (...) Yes, it will be interesting to (...) (21 years ago, 9-May-04, to lugnet.technic)
| | | | | Re: SSClagorpion
|
| OK, here is an interesting problem I'd not thought about. When the legs are like this (only down legs shown) A\_ B _/D C E\_ F _/H G The body tips over toward leg G. I'm sure this would happen to all four corners. I know that I need to strengthen (...) (21 years ago, 9-May-04, to lugnet.technic)
| | | | | Re: SSClagorpion
|
| (...) (URL) above picture shows a body that is longer than it is wide. I'm going to rearchitect the legs so that they get longer and more swept back as you move toward the back legs. This should end the issue falling over. I'm also going to try to (...) (21 years ago, 9-May-04, to lugnet.technic)
| | | | | Re: SSClagorpion
|
| (...) oh hey wow, I see how the motion is transfered back towards the rear of the structure. Neat. Hey, but we are gonna aim to make a robotic claw aren't we, in addition to the sensor funtionality you mentioned. Right? This is where Kevin and I (...) (21 years ago, 10-May-04, to lugnet.technic)
| | | | | Re: SSClagorpion
|
| (...) Eric, How much of the above message did you read? :) Never mind, don't answer that. :) Yes, I'm planning on making a pneumatic claw. Looking at the diagram Kevin posted, I expect to re-build the arm. I'm just playing around with ideas. Steve (21 years ago, 10-May-04, to lugnet.technic)
| | | | | Re: SSClagorpion
|
| (...) I know, I know, I was just asking to ask. Also, in a round about way I was both aknowledging your Arm(s) build and at once relegating my duty to the tail build. (...) sweet. e (21 years ago, 10-May-04, to lugnet.technic)
| |
