 | | Re: SSClagorpion
|
|
(...) I suspect once you get the switches added, there will be more support. But it seems like a stop at one or both ends would not be a bad idea. (...) Yes, that leg looks very good. (...) The touch sensors don't have to be in the feet. They could (...) (20 years ago, 6-May-04, to lugnet.technic)
|
| |
| | Re: SSClagorpion
|
|
(...) Welcome to the "Department of Redundancy Department". LOL! (...) I don't think so as long as the piston head is not flexed too much side to side. Too much misaligment can cause seal leakage. Also I can try to add a mechanical stop that (...) (20 years ago, 6-May-04, to lugnet.technic)
|
| |
| | Can someone identify this 'instruction kit' - red flip top hard case
|
|
I ended up with this 'red container' with a flip top from a collector we bought out, but have been unable to identify it's kit number or where it would have originally come from. Inside the red flip top case is a series of instructions for various (...) (20 years ago, 6-May-04, to lugnet.technic)
|
| |
| | Re: SSClagorpion
|
|
(...) Makes sense to me. Makes sense to me. Makes sense to me. Makes sense to me. :) The prototype leg looks very good. However, I do have one question. Given the angle of the leg, there will be pressure on the sidestep piston to pull the piston (...) (20 years ago, 6-May-04, to lugnet.technic)
|
| |
| | Re: SSClagorpion
|
|
(...) I don't know if this timing diagram helps explain the verbiage above. Forward slashes represent the pistons expanding, and the backward slashes represent the pistons contracting. Horizontal lines represent unchanging pistons. When all four (...) (20 years ago, 6-May-04, to lugnet.technic)
|
