 | | Re: Custom Pneumatic Parts —David Laswell
| | | | (...) It might be more difficult than you'd think. If you try to splice two tubes together you could very easily ruin the integrity of the internal seal (either by creating a bump where it'll catch or a void where it'll lose its seal), causing your (...) (22 years ago, 13-May-03, to lugnet.technic)
| | | | | | | | | | Re: Custom Pneumatic Parts —Gregory Muri
| | | | | Actually Dave I was thinking of modifying a cylinder by using the end caps and replacing the tube with a custom length and a rod/piston assembly to match. Replacing the connector on the end of the rod would be easy using a #1 angle connector that (...) (22 years ago, 13-May-03, to lugnet.technic)
| | | | | | |
