Subject:
|
Re: Gear question
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Tue, 15 Apr 2003 02:19:19 GMT
|
Viewed:
|
628 times
|
| |
|
|
In lugnet.technic, James Loewen writes:
>
>
> I have a question about a certain kind of technic gear, specifically the 14
> tooth bevel gear #4143. Is it thin enough that you could use an 8 tooth gear
> on the same axle as one of these and not have it rub against the 14 tooth
> gear on the axle perpendicular to it? I'm wondering because I don't have any
> of these at the moment, but I would probably buy some if they can do this.
Hmmmmm if you're asking what I think you're asking, then I'm pretty sure the
answer is "no". I think there's enough room for a bush, but not an 8t gear.
ROSCO
|
|
Message is in Reply To:
 | | Gear question
|
| I have a question about a certain kind of technic gear, specifically the 14 tooth bevel gear #4143. Is it thin enough that you could use an 8 tooth gear on the same axle as one of these and not have it rub against the 14 tooth gear on the axle (...) (22 years ago, 15-Apr-03, to lugnet.technic)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
