|
|
 | | Re: DETAILS: 8011 Jango Fett & 8012 Super Battle Droid
|
| (...) Okay, so I'll just have to go to UK then :) Perhaps I could get put rowing boat into the ocean via some rivers and then row down to England :) Sounds awesome though, not the rowing part, but going to an UK meeting :) /Tobbe (URL) (23 years ago, 3-Apr-02, to lugnet.technic)
| | | | | Re: New Parts
|
| (...) I remembered the 1/2 pin today, I usually attach the half beams with a mixture of 3/4 and 1/2 pins. Makes them fit better. /Tobbe (URL) (23 years ago, 3-Apr-02, to lugnet.technic)
| | | | | Re: New Parts
|
| (...) Here's the list I made of replies I got when I started a similar discussion last year: 1/2 connector (i.e a lift arm width pin on each side of the central flange) 3L lift arm 3L lift arm with axle hole in the centre 4L lift arm 5L lift arm (...) (23 years ago, 3-Apr-02, to lugnet.technic)
| | | | | RE: New Parts
|
| (...) robots when I can't be bothered to put in idler wheels - would be better though if you could get some that were flat (and different sizes) not domed, as you can't make nice large areas by abutting them. (23 years ago, 3-Apr-02, to lugnet.technic)
| | | | | Re: New Parts
|
| Hi, Impressive work! I would like lego to manufacture a motor similar to the 2 supplied with mindstorms, but which utilizes a female conection with the axels apposed to the curent male setup. This is a picture of a conector I wish was in exsistence. (...) (23 years ago, 3-Apr-02, to lugnet.technic)
|
|
