 | | Re: Motor with Gear Reduction ??!??
|
|
(...) the (...) Try this page: "(URL) couldn't fit it in one line so some copy&paste should be used. (Looking at the table, though, I think 60 rpm is too slow for the new geared motor) - David (25 years ago, 12-Apr-01, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: Pneumatic Pump Testing Goes Hi Tech
|
|
(...) Thanks for the identification of the tire pressure gauge. I reckon the stores will soon be doing a brisk trade in them. But I would hesitate to use the word *calibrate* - the pressure sensor is a far more delicate device than the tire gauge. (...) (25 years ago, 12-Apr-01, to lugnet.robotics, lugnet.technic, lugnet.build, lugnet.dacta)
|
| |
| | Re: Pneumatic Pump Testing Goes Hi Tech
|
|
(...) Methinks it'll be muscle wire or air muscle or something akin... Well, if you don't need the pneumatics any more, how about "donating" them to me :-) (25 years ago, 12-Apr-01, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: looking for inventories of 8064 & 9v power pack
|
|
(...) have (...) Hi Jonathon If you build the 4 models in the instructions, re-using parts if you've already used them, or adding from your collection as required, you should end up with a close approximation of the set's inventory. I doubt if Lego (...) (25 years ago, 12-Apr-01, to lugnet.technic, lugnet.db.inv)
|
| |
| | Re: looking for inventories of 8064 & 9v power pack
|
|
(...) I need an inventory of the whole set so that I can identify what parts I dont have that are needed for an 8064 so that I can obtain them. (25 years ago, 11-Apr-01, to lugnet.technic, lugnet.db.inv)
|
