 | | Shock absorbers stiffness
|
|
An approximate measurement of stiffness of different shock absorbers at full compression. (3 URLs) Philo> (16 years ago, 13-Apr-09, to lugnet.technic, FTX)
|
| |
| | Uncommon use of Bionicle masks
|
|
LLL, Inof presented this house over on 1000steine, note the unusual awnings at the first floor: (URL) (16 years ago, 9-Apr-09, to lugnet.build.arch, lugnet.technic.bionicle, lugnet.town)
|
| |
| | Re: Help needed on gear spacing, and another question
|
|
(...) No! They're properly aligned. ;) They just look like that, because the way the worm termination is done. However the screw works continuous and smoothly. (16 years ago, 8-Apr-09, to lugnet.technic, FTX)
|
| |
| | Re: Help needed on gear spacing, and another question
|
|
(...) Is it just me, or do those worm gears look like the haven't been aligned properly? (16 years ago, 8-Apr-09, to lugnet.technic, FTX)
|
| |
| | "Deathstrider" Droid Host Unit and a centipede
|
|
I've been thinking for awhile that a mantis-like creation would fit in well with my Vedraan Empire sub-theme of Silicon Psyche. Check out the "Deathstrider" droid host unit- (URL) the past few years, I've accumulated a lot of metallic Bionicle (...) (16 years ago, 8-Apr-09, to lugnet.announce.moc, lugnet.build.mecha, lugnet.general, lugnet.technic.bionicle)
|
| |
| | Re: Help needed on gear spacing, and another question
|
|
While the worm and 1x4 rack pitch are not the same and they do not mesh perfectly, it is still possible to make them work together in a reliable way. You may see one example below, (URL) Originally posted at TechnicBRICKs (URL) (16 years ago, 7-Apr-09, to lugnet.technic, FTX)
|
| |
| | Re: Help needed on gear spacing, and another question
|
|
(...) For instance, have a "floating" worm-gear-based gearbox sliding along that axle, with the 8t gears engaging an external stationary rack? If the worm gear doesn't have very far to travel, you could also substitute a rack gear or two for a (...) (16 years ago, 3-Apr-09, to lugnet.technic)
|
| |
| | Re: Help needed on gear spacing, and another question
|
|
(...) Although not by far as nice and compact as Mike's suggestion I stumbled upon the following solution after a bit of tinkering: (URL) (16 years ago, 3-Apr-09, to lugnet.technic)
|
| |
| | Re: Help needed on gear spacing, and another question
|
|
(...) Rafe, Must the worm gear mesh directly with the gear rack? Or, could you put a 24tooth gear in between? (worm->24->rack) Steve (16 years ago, 3-Apr-09, to lugnet.technic)
|
| |
| | Re: Help needed on gear spacing, and another question
|
|
(...) Try this inversion trick: (URL) (16 years ago, 3-Apr-09, to lugnet.technic)
|
