 | | Re: Technicopedia Update
|
|
Thank you very much for the flash back into time. I grew up on Technic / Expert Builder, but have stored it all away. Very exciting to see it again! Great work! Thanks, Scott (16 years ago, 17-Oct-08, to lugnet.technic)
|
| |
| | Re: Technicopedia Update
|
|
(...) Fantastic news! I'm really glad you're still going with this :-) (16 years ago, 17-Oct-08, to lugnet.technic)
|
| |
| | Re: Technicopedia Update
|
|
(...) Always appreciated when it arrives! Philo (16 years ago, 17-Oct-08, to lugnet.technic, FTX)
|
| |
| | Re: Three metres long heavy beam transport
|
|
(...) The pictures in my post disappeared unfortunately (another webserver). But in a meanwhile I changed something to give it a new look. Actually it is a new model but this time it didn't took me two years to build it. Two months were enough. (...) (16 years ago, 16-Oct-08, to lugnet.modelteam, lugnet.technic, FTX)
|
| |
| | Re: Technicopedia Update
|
|
At long last, I have completed the year 1990 and added it to (URL) Technicopedia>. Sets 8064, 8094, 8825, 8830, 8840, and 8850 have been added. It has been 7 months since the last update. (URL) Eric Albrecht (16 years ago, 16-Oct-08, to lugnet.technic, FTX) !!
|
| |
| | Re: 12 Tooth bevel gear case
|
|
(...) The (URL) 10178 Motorized Walking AT-AT> set uses them to drive the legs because a lot of torque is needed to move all that weight -- you can hear the motor straining with every step. (16 years ago, 15-Oct-08, to lugnet.technic, FTX)
|
| |
| | Re: How can I align something to this angle?
|
|
"Brian Davis" <brdavis@iusb.edu> wrote in message news:K8H6pK.oGs@lugnet.com... (...) LEGO Factory palette currently available through LDD. I build a lot of virtual stuff in that program because it's the most user-friendly program I've found for (...) (16 years ago, 10-Oct-08, to lugnet.technic)
|
| |
| | Re: How can I align something to this angle?
|
|
(...) There are several possibilities (45° angle between their long axis? Between their short axis?), but note that by using pieces that slide along axles you can get any spacing (and therefore any angle). Here's a really simple example (Deeplink): (...) (16 years ago, 9-Oct-08, to lugnet.technic)
|
| |
| | Re: How can I align something to this angle?
|
|
(...) [LDrawPart 924] Gives you exactly 45 degrees, only 1 stud wide, pretty strong, and a bit of flexibility. Using 3/4 pins and liftarms you should be able to attach it to beams and keep it all inside 2 studs wide. ROSCO (16 years ago, 9-Oct-08, to lugnet.technic, FTX)
|
| |
| | How can I align something to this angle?
|
|
I need to align a technic brick as close as possible to 45 degrees as the part geometry and physical limitations would allow it. I've studied some probable solutions and can come close with ordinary technic bricks and plates in between, but I'm (...) (16 years ago, 8-Oct-08, to lugnet.technic)
|
