Subject:
|
Re: How can I align something to this angle?
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Thu, 9 Oct 2008 01:11:42 GMT
|
Viewed:
|
14769 times
|
| |
|
|
In lugnet.technic, Geoffrey Hyde wrote:
| |
I need to align a technic brick as close as possible to 45 degrees as the
part geometry and physical limitations would allow it.
I’ve studied some probable solutions and can come close with ordinary
technic bricks and plates in between, but I’m wondering how short I can get
the mounting and keep it in a 2-stud width.
It needs to be rigid yet have slight flexibility of movement in it. I would
also prefer it if the parts were common to many LEGO sets as I don’t own a
lot of super-rare or specialty pieces.
|
Gives you exactly 45 degrees, only 1 stud wide, pretty strong, and a bit of
flexibility. Using 3/4 pins and liftarms you should be able to attach it to
beams and keep it all inside 2 studs wide.
ROSCO
|
|
Message is in Reply To:
 | | How can I align something to this angle?
|
| I need to align a technic brick as close as possible to 45 degrees as the part geometry and physical limitations would allow it. I've studied some probable solutions and can come close with ordinary technic bricks and plates in between, but I'm (...) (16 years ago, 8-Oct-08, to lugnet.technic)
|
4 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
