|
|
 | | Re: Need to figure out how to get this motor unit attached.
|
| (...) Hi Geoffrey, I think the easiest way to turn gearing through use of the worm gear, however as others will point out a worm gear is not very efficient gearing down mechanism, also if this is run for several hours at a time, the meshed gears (...) (18 years ago, 19-Apr-06, to lugnet.technic)
| | | | | Mindstorms.NET Request for Comments
|
| I've been working with José David Parra on the next version of his (URL) RCX.NET> project, because 1.) the NXT system is coming out, and 2.) RCX.NET is basically a .NET wrapper of Spirit.ocx, which means it's not so nice to program with. Another (...) (18 years ago, 17-Apr-06, to lugnet.robotics, lugnet.technic, lugnet.announce, lugnet.robotics.rcx, lugnet.robotics.scout, FTX)
| | | | | Re: Request for info on the Control Lab Interface.
|
| (...) Another question: Does this device work with serial port to USB adapters? I'd like to make this code as robust as possible, so this would be nice to know. If so, then I'd need to know if those adapters map themselves to the equivalent of COM1, (...) (18 years ago, 14-Apr-06, to lugnet.robotics, lugnet.technic, FTX)
| | | | | Need to figure out how to get this motor unit attached.
|
| (URL) trying to figure out how to attach the new motor assembly and it's one-way drive train shown in pics 0-4 in this folder to the hopper assembly, at the point where the old assembly engaged the hopper itself, in pic 10 in the brickshelf folder (...) (18 years ago, 14-Apr-06, to lugnet.technic)
| | | | | Re: Request for info on the Control Lab Interface.
|
| (...) Thanks for your information! I was also sent via email a very helpful page: (URL) His (URL) Research Page> has source code, which was also helpful. In fact, his ActiveX control might be useful for NQC. I had trouble getting it to connect to my (...) (18 years ago, 12-Apr-06, to lugnet.robotics, lugnet.technic, FTX)
|
|
