 | | Re: automatic transmission
|
|
(...) I have never heard of this before... but I suppose you could do it with and RCX and two motors. think about it... if you had 2 inputs(the motors) into the transmission and 1 output with the RCX controlling which motor is in use and at what (...) (21 years ago, 3-Feb-04, to lugnet.technic)
|
| |
| | automatic transmission
|
|
I was out of ideas for what to do next, my "snow plow" or "snowblower" or whatever you like to call it, is finished and working, only need a truck or anything behind it to look cool. MLCad file will be avaiable soon... But today I was reading the (...) (21 years ago, 3-Feb-04, to lugnet.technic)
|
| |
| | Re: New crane MOC
|
|
(...) thanks tobbe. i will be sure to get lots of good pictures before it falls. i have seen the pictures of the TJ incident. bob Bob Kojima ko@fial.com (URL) Incorporated Telecom Monitoring Solutions 4343 SW Corbett Ave Portland, OR 97239 (...) (21 years ago, 3-Feb-04, to lugnet.technic)
|
| |
| | Re: New crane MOC
|
|
(...) thanks TJ. you are the crane master so a complement from you means a lot to me! i had to place a lot of orders for 1x5 liftarms thin to complete all the cross bracing. the red ones are hard to come by and the bricklink stores only have 1 or (...) (21 years ago, 3-Feb-04, to lugnet.technic)
|
| |
| | Re: Motion considerations when RCXing The Improved and New Old Miller Gustav's Post Mill
|
|
(...) gears and clutches for that. I've tried a crude version locking differential boxes together, and driving off the gears on the ends though. Okay, two ways to get a simple two-shaft concentric drive: The first is, as mentioned above, use a (...) (21 years ago, 3-Feb-04, to lugnet.castle, lugnet.technic, FTX)
|
