|
| | Re: Pneumatic hoses
|
| (...) sells fish tanks & supplies. We used it to make a couple of long (1.5m) tubing lengths, it worked very well and was basically a perfect fit on the Lego peumatic pieces. JohnG, GMLTC (21 years ago, 11-Dec-03, to lugnet.technic)
| | | | Re: Pneumatic hoses
|
| (...) There's always fuel hose for model airplanes, but that's expensive (high grade silicone to be fuel and heat resistant). Another source is your well sorted car part dealer, they have thin vacuum hoses that might fit. A friend used this and it's (...) (21 years ago, 11-Dec-03, to lugnet.technic)
| | | | Re: 2004 Products see?
|
| (...) What you got there is a regular sized antenna, put through a 1x1 cone, and then through the hole on a 1x1 clip/holder/thingy. You can see the butt of the antenna on the other side. Most defenitly a regular sized antenna. It would be nice to (...) (21 years ago, 10-Dec-03, to lugnet.pirates, lugnet.castle, lugnet.technic.bionicle, lugnet.technic, FTX)
| | | | Re: 2004 Products see?
|
| It looks like the trans-orange antennae on the side of the 8380 race set (1st race set listed): (...) is a new, shorter size antenna. Anyone else think so? David "Fuzzy" Gregory (21 years ago, 10-Dec-03, to lugnet.pirates, lugnet.castle, lugnet.technic.bionicle, lugnet.technic, FTX)
| | | | Re: Pneumatic hoses
|
| Hi Morten, for the interconnection of a pneumatic remote control with the model I use the isolation tube of the cables used for the electric installation of a house. It has a cross section of 1.5 mm^2. The isolation fits perfectly and air tight in (...) (21 years ago, 9-Dec-03, to lugnet.technic)
| |